Water Cut Meters from Drexelbrook

Water (BS&W) Cut Meters

The water cut is the proportion of water collected in a well to the total liquids produced. As crude oil and hydrocarbons travel through a pipeline, a water cut meter monitors the amount of water (cut). BS&W is the amount of non-hydrocarbon contaminants, dirt (sediment), and water included in a crude oil shipment. The lower the BS&W, the better.  Water content determination and BSW have been a persistent and long-standing issue for the oil and gas industry.

Water cut meters measure the water cut (or BS&W) of oil flowing from a well,  a separator, crude oil transfer in pipelines, and tanker loading. 


Drexelbrook has been the global leader in capacitive-based water cut measuring. Drexelbrook has the industry's highest pressure and temperature ratings, and their capacitive probes can withstand pressures of up to 1500 psi and temperatures of up to 450°F. 

The Universal IV CM Series from Drexelbrook is a high-quality water cut meter with a range of 0-50 percent in light oil and 0-80 percent in heavy oil. 

The Universal IV CM Series builds upon Drexelbrook's expertise in RF Admittance, which enables the electronics to disregard paraffin and other coatings that accumulate on the probe. 

The Universal IV CM has a one-of-a-kind Cote Shield built into the Universal IV CM series and allows the instrument to disregard a pre-determined length of the sensing element. It contains a Perm-A-Seal sensing device that eliminates the need for epoxy coatings, which wear out and need costly maintenance. 

Field setup is available anywhere along the two-wire loop when using this water cut meter with Drexelbrook's HRTWin or the STExplorer PC program. 

Choose the Universal IV CM sensing element depending on pipe size, wetted portions, NACE requirements, and pressure/temperature requirements. Drexelbrook has a broad assortment of probes to suit almost any purpose. 

All water cut meters have a built-in LCD and keypad, are pre-calibrated at the manufacturer, and need just one point confirmation. 

The Universal IV CM water cut meter is intrinsically safe and approved for Class I, Division 1, and Zone 0 hazardous areas.

For more infomration in New England, contact Piping Specialties / PSI Controls. Call 800-223-1468 or visit https://psi-team.com.

Piping Specialties is Your Preferred Ball Valve Automation Specialist in New England

Ball Valve Automation

Piping Specialties / PSI Controls offer automated ball valve assemblies ranging from 1/2" to 48" that provide first-class quality, outstanding performance, and durability. The Piping Specialties valve automation shop inspects and tests every valve assembly before shipping from our facility. 

The valve automation department at Piping Specialties builds ball valve assemblies that save you substantial time on the job site. Automation specialists are highly trained, and all valve assemblies (both pneumatic and electric) receive functional testing before being shipped out to customers. Valve assembly inspection and validation occur before shipment using serialized and labeled quality assurance documentation. Assembly drawings, actuator sizing verification, and datasheets are available on request. 

Contact Piping Specialties / PSI Controls with your next automated ball valve requirement.


Piping Specialties / PSI Controls
https://psi-team.com
800-223-1468